With a flat bladed screw driver or pocket knife, gently pry out the square knock-out plug... Press in the new knock-out plug that came with your tank bag. It has the receiving end of the ... Adjust the strap that goes underneath the seat to approximately 10 ½" - 11"... Lift the seat of the Silver Wing and place the adjustable strap as far forward as it will go, just ... The quick release clips should just peek out at the very front and bottom of the seat when ... Attach the tank bag to the quick release clips. It should be a tight fit as you don't want the bag ... Go to the front of the bag and attach the button snap to the receiving end on the square ... We're not done yet, but step back and take a quick look. Keep in mind that if the ... Remove the tank bag from the Silver Wing. Inside your bag, when shipped, there was a ... The ideal installation temperature is between 50-90°F. You can heat up the ... Also warm the Paint Protection Film if it is not within the ideal installation temperature of ... Make sure your hands are clean. Remove the film from the backing sheet being careful ... Carefully place the Paint Protection Film on the Silver Wing. Pay more attention ... With a credit card, or a small squeegee, working from the center out, press the solution ... After getting the main bubbles and solution out, go back with your hair dryer and continue ... Using your fingers or squeegee and the hair dryer, work towards the bottom of the film... Once the Paint Protection Film is installed properly, it becomes virtually invisible and can ... Re-attach the tank bag, then stand back and take a look at your work. Good job! You ...